schematic sleeve sleeve shunt center pin 0.440 0.002 11.18 0.05 recommended panel mtg hole 0.65 16.5 center pin/jack size (see table) 1.03 26.3 0.37 9.4 0.51 12.9 0.156 3.96 0.62 15.7 0.090 2.29 maximum panel thickness center pin sleeve shunt sleeve panel mount seal o-ring mating plug seal o-ring hex nut 7/16-32 un thread flat washer 0.062 typ 1.57 0.156 3.96 0.040 1.02 0.150 3.81 0.156 3.96 recommended pcb layout (component side) center pin sleeve sleeve shunt c l c l notes: 1. hex nut, flat washer, and panel o-ring supplied unassembled 2. dimensions shown for reference only. 3. material: housings, hex nut - copper alloy, nickel plated insulator housing - thermoplastic o-rings - neoprene rubber, lubricated with synthetic grease terminal insulators - phenolic flat washer - steel, nickel plated pin, spring, terminals - copper alloy, silver plated 4. this product is rohs compliant do not scale drawing revisions apvd by date eco number rev rev part no. name of sheet apvd chkd by date drawn scale first used on spec no. spec no. material finish unless otherwise specified temper lbs/m mult width size this drawing describes a design considered proprietary in nature, developed and manufactured by switchcraft inc. and is released on a confidential basis for identification purposes only. b a 26591 8/6/10 rs tjk * 2:1 7/23/09 pnk rs 8/6/10 tjk 8/6/10 1 1 sealed power jacks straight pc, rohs pcl712as, PCL722AS a 1. all dimensions in inches - two place decimals 0.02 - three place decimals 0.005 solidworks cad file customer drawing
|
