high voltage silicon rectifier voltage range 2500 to 5000 volts current 0.2 ampere rectron semiconductor technical specification features * low cost * low leakage * low forward voltage drop * high current capability maximum ratings and electrical characteristics ratings at 25 o c ambient temperature unless otherwise specified. single phase, half wave, 60 hz, resistive or inductive load. for capacitive load, derate current by 20%. electrical characteristics (at t a = 25 o c unless otherwise noted) r2500 thru r5000 do-15 maximum ra tings (at t a = 25 o c unless otherwise noted) dimensions in inches and (millimeters) notes : measured at 1 mh z and applied reverse voltage of 4.0 volts. mechanical data * case: molded plastic * epoxy: device has ul flammability classification 94v-o * lead: mil-std-202e method 208c guaranteed * mounting position: any * weight: 0.35 gram 2002-12 ratings maximum recurrent peak reverse voltage maximum rms volts maximum dc blocking voltage maximum average forward rectified current at t a = 50 o c peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method) typical junction capacitance (note) operating and storage temperature range symbol v rrm v dc i o i fsm c j t j , t stg v rms volts volts volts mamps 200 30 -55 to + 150 amps pf 0 c units r2500 2500 r4000 r5000 r3000 4000 3000 5000 1750 2800 2100 3500 2500 4000 3000 5000 30 at rated dc blocking voltage characteristics maximum full load reverse current average, full cycle v f symbol i r units 4.0 5.0 uamps maximum dc reverse current maximum instantaneous forward voltage at 0.2a dc volts @t a = 25 o c @t a =100 o c 5.0 50 .375, (9.5mm) lead length at t l = 75 o c r2500 r4000 r5000 r3000 30 uamps 3.0 1.0 ( 25.4 ) min. .230 ( 5.8 ) .300 ( 7.6 ) 1.0 ( 25.4 ) min. .140 ( 3.6 ) .104 ( 2.6 ) dia. .034 ( 0.9 ) .028 ( 0.7 ) dia.
rectron rating and characteristic curves ( r2500 thru r5000 ) fig. 2 - maximum non-repetitive forward peak forward surge current, (a) number of cycles at 60hz 60 50 40 30 20 10 0 1 10 100 8.3ms single half sine-wave ( jedec method ) surge current single phase half wave 60hz inductive or resistive load fig. 1 - typical forward current average forward current, (ma) ambient temperature, ( ) derating curve 0 50 100 150 175 250 200 150 100 50 0 fig. 3 - typical reverse characteristics instantaneous reverse current, (ua) percent of rated peak reverse voltage, (%) t j = 25 0 20 40 60 80 100 120 140 10 .01 .02 .04 .06 .1 .2 .4 .6 1.0 2 4 6
|
