irrtmer vorbehalten. errors and omissions excepted. you are facing dif? culties re? lling your ink cartridges or require more information about the re? lling procedure? please feel free to contact us. the address is as follow: ink.co.uk ? customer care department ? po box 987 C canterbury ? ct1 9ef ? info@ink.co.uk logos, brand names and product descriptions are the property of their respective manufacturers and are used for reference purposes only. re? ll instructions epson T0611 | t0612 | t0613 | t0614 | t0615 please carefully read these instructions before re? lling your ink cartridges. always carry out the ink re? ll process on a dirt resistant mat and have a moist cloth to hand to quickly remove any ink spillage. the instructions apply only to the ink cartridges referred to above. the syringe and ink should be kept away from children. we accept no responsibility for any damage caused by inadequate or incorrect actions carried out during the re? lling process. the re? lling of ink cartridges is carried out at your own risk. an empty ink cartridge of this type can be re? lled with approximately 8 ml of ink. in order to re? ll an ink cartridge, a syringe ? lled with ink is required. open the cap of one of the enclosed ink holders, which also acts as a syringe. now insert the enclosed blunt needle using a twisting motion into the opening. hold the lower part of the ink holder with your thumb and fore? nger and twist it counter clockwise into the appliance. then seal the ink outlet opening with an adhesive tape and place the ink cartridge in an upright position. next, using the tool provided, drill a hole approximately 7 mm deep through the designated opening. drill carefully, as there are 2 inner walls to drill through. 3. 2. now insert the syringe into the newly made opening and ? ll the ink chamber slowly and carefully until just below the opening. should some of the ink leak out, simply remove it by using the syringe. seal the newly drilled hole with an adhesive strip and then leave the ink cartridge for a few hours to allow the ink enough time to spread throughout the ink chamber. finally, the ink cartridge chip ink ? uid level reading needs to be reset. in order to do this, press the reset device (not included with the re? ll kit set) pins against the ink cartridge chip contact. after removing the adhesive tape from the ink outlet area, the re? lled ink cartridge can then be inserted into the printer. please be aware of the possibility of ink leakage. 6. 5. 4. 1.
|
