16 a spdt miniature power relay features ? dielectric strength 5000 vrms ? low cost ? epoxy sealed version available ? 16 amp switching ? isolation spacing greater than 10 mm ? reinforced insulation, en 60730-1 (vde 0631, part 1), en 60335-1 (vde 0700, part 1) ? ul, cur file e44211 ? vde 40006031 zettler electronics gmbh fax +49 89 800 97 200 www.zettlerelectronics.com office@zettlerelectronics.com 0 97 800 89 +49 te l. germany puchheim, d-82178 junkersstrasse 3, 2004-09-27 AZ762 general data life expectancy minimum operations mechanical 1 x 10 7 electrical 1 x 10 5 at 16 a 250 vac res. operate time (typical) 7 ms at nominal coil voltage release time (typical) 3 ms at nominal coil voltage (with no coil suppression) dielectric strength 5000 vrms coil to contact (at sea level for 1 min.) 1000 vrms between open contacts insulation 1000 megohms min. at 20c resistance 500 vdc 50% rh insulation c250 (according to overvoltage category: iii din vde 0110, pollution degree: 3 iec 60664-1) nominal voltage: 250 vac dropout greater than 10% of nominal coil voltage ambient temperature at nominal coil voltage operating -40c (-40f) to 85c (185f) storage -40c (-40f) to 105c (221f) vibration 0.062" (1.5 mm) da at 10?55 hz shock 10 g enclosure p.b.t. polyester terminals tinned copper alloy, p. c. max. solder temp. 270c (518f) max. solder time 5 seconds max. solvent temp. 80c (176f) max. immersion time 30 seconds weight 14 grams packing unit in pcs 20 per plastic tube / 1000 per carton box contacts arrangement spdt (1 form c) spst (1 form a, 1 form b) ratings resistive load: max. switched power: 480 w or 4432 va max. switched current: 16 a max. switched voltage: 150 vdc* or 440 vac * note: if switching voltage is greater than 30 vdc, special precautions must be taken. please contact the factory. rated load ul, cur 16 a at 277 vac resistive, 100k cycles [3] 16 a at 277 vac resistive, 50k cycles [1] 1 hp at 250 vac (1 form a) [1] 1 / 2 hp at 125 vac (1 form a) [1] tv-5 at 125 vac (1 form a) [1] 16 a at 277 vac resistive, 75k cycles [2] b300 pilot duty [2] r300 pilot duty [2] vde 16 a at 250 vac resistive, [1] [2] and [3] 9 a at 250 vac, inductive (form a) [1] [2] and [3] material silver cadmium oxide [1] or silver tin oxide [2] or silver nickel [3]. gold plating available resistance < 50 milliohms initially coil power at pickup voltage 196 mw (typical) max. continuous 1.7 w at 20c (68f) ambient dissipation temperature rise 26c (47f) at nominal coil voltage max. temperature 130c (266f) notes 1. all values at 20c (68f). 2. relay may pull in with less than ?must operate? value. 3. specifications subject to change without notice.
2004-09-27 zettler electronics gmbh fax +49 89 800 97 200 www.zettlerelectronics.com office@zettlerelectronics.com 0 97 800 89 +49 te l. germany puchheim, d-82178 junkersstrasse 3, AZ762 mechanical data [5.04] .198 [5.04] .198 [15.12] .595 [2.5] .098 * not used on 1 form a relay [? 1.3] [2.5] .098 .198 [5.04] .198 [5.04] [15.12] [7.5] 6 x .035 [0.9] [7.5] 6 x ? .050 6 x .020 [0.5] .098 [2.5] .595 .295 2 x ? .024 [? 0.6] .295 2 1 3 6 4 7 5 8 2 1 4 7 5 8 * * [? 1.0] 2 x ? .040 [29.3] 1.155 max. [13.0] .512 max. [0.3] .012 [16.0] .63 max. [3.6] .142 pc board layout wiring diagrams 1 form c 1 form a viewed toward terminals viewed toward terminals dimensions in inches with metric equivalents in parentheses. tolerance: .010" relay ordering data coil specifications ? dc coil order number* nominal coil must operate max. continuous coil resistance 1 form c 1 form a vdc vdc vdc ohm 10% 5 3.5 10.2 62 AZ762?1a?5d AZ762?1c?5d 6 4.2 12.3 90 AZ762?1a?6d AZ762?1c?6d 9 6.3 18.3 200 AZ762?1a?9d AZ762?1c?9d 12 8.4 24.7 360 AZ762?1a?12d AZ762?1c?12d 18 12.6 37.0 810 AZ762?1a?18d AZ762?1c?18d 24 16.8 49.4 1,440 AZ762?1a?24d AZ762?1c?24d 48 33.6 98.0 5,760 AZ762?1a?48d AZ762?1c?48d 60 42.0 112.9 7,500 AZ762?1a?60d AZ762?1c?60d 110 77.0 206.9 25,200 AZ762?1a?110d AZ762?1c?110d * ?1a? or ?1c? denote silver cadmium oxide contacts. substitute ?1b? in place of ?1a? for 1 form b contact. add suffix ?e? to ?1a? or ?1b? or ?1c? for silver tin oxide contacts. add suffix ?b? to ?1a? or ?1b? or ?1c? for silver nickel contacts. add suffix ?e? at the end of order number for sealed version. add suffix ?a? at the end of order number for gold plated contacts.
|
