? epcos ag 2009. reproduction, publication and dissemination of this data sheet, enclosures hereto and the information contained therein without epcos prior express consent is prohibited. saw components saw tx filter pcs / wcdma band ii series/type: ordering code: b9459 B39192B9459P810 date: version: november 13, 2009 2.0
2 november 13, 2009 b9459 1880.0 mhz please read cautions and warnings and important notes at the end of this document. saw components saw tx filter data sheet application n low-loss rf filter for mobile telephone pcs and wcdma systems, transmit path (tx) n high selectivity n usable passband 60 mhz n impedance at input and output 50 w n unbalanced to unbalanced operation features n package size 1.4 x1.1 x 0.4 mm 3 n package code qcs5u n rohs compatible n approximate weight 0.003 g n package for s urface m ount t echnology ( smt ) n ni, gold-plated terminals n e lectrostatic s ensitive d evice ( esd ) 0,325 bottom view 0,4 side view top view 0,575 1 5 4 3 2 0,25 1,1 1,4 0,5 0,5 pin configuration n 1 input unbalanced n 4 output unbalanced n 2,3,5 to be grounded 1 4 3 2,5
3 november 13, 2009 b9459 1880.0 mhz saw components saw tx filter data sheet please read cautions and warnings and important notes at the end of this document. characteristics temperature range for specification: t = C30 ?c to +85 ?c terminating source impedance: z s =50 w terminating load impedance: z l =50 w b9459 min. typ. @ 25 ?c max. center frequency f c CC 1880.0 CC mhz maximum insertion attenuation 1850.625...1909.375 mhz a max CC 2.6 3.8 1) 1) valid in temperature range -20 ? c to +75 ? c. specified for +85 ? c: 4.2db db @f carrier 1852.4 ...1907.6 mhz a wcdma 2) 2) attenuation of wcdma signal (powertransferfunction). please refer to annotation on page (4). CC 2.5 3.5 db amplitude ripple (p-p) 1850.625...1909.375 mhz da CC 1.3 2.9 db error vector magnitude 3) 3) error vector magnitude (evm) based on definition given in 3gpp ts 25.141. @f carrier 1852.4 ...1907.6 mhz evm CC 1.5 4.5 % input vswr 1850.625...1909.375 mhz CC 1.9 2.2 output vswr 1850.625...1909.375 mhz CC 1.9 2.2 attenuation a 0.0 ...1550.0 mhz 32 36 CC db 1550.0 ...1580.0 mhz 35 37 CC db 1580.0 ...1770.0 mhz 30 35 CC db 1770.0 ...1830.0 mhz 14 18 CC db 1930.625...1990.0 mhz 33 4) 4) valid in temperature range -20 ? c to +85 ? c. specifieded for -30 ? c: 30db 36 CC db @f carrier 1932.4 ...1987.6 mhz a wcdma 2) 34 37 CC db 1990.0 ...2032.0 mhz 35 38 CC db 2032.0 ...2500.0 mhz 35 38 CC db 2500.0 ...3700.0 mhz 30 35 CC db 3700.0 ...3820.0 mhz 35 47 CC db 3820.0 ...6000.0 mhz 25 35 CC db
4 november 13, 2009 b9459 1880.0 mhz please read cautions and warnings and important notes at the end of this document. saw components saw tx filter data sheet annotation for characteristics section attenuation of wcdma signal (powertransferfunction, a wcdma ) is determined by f carrier according to 3gpp ts 25.101 (e.g. for passband, f carrier ranges from 1852.4 mhz (low- est tx channel) to 1907.6 mhz (highest tx channel)). h rrc (f) is the transfer function of the root-raised cosine transmit pulse shaping filter according to 3gpp ts 25.101 with the following normalization: maximum ratings operable temperature range t C40/+85 ?c storage temperature range t stg C40/+85 ?c dc voltage v dc 5 v esd voltage v esd 50 1) 1) acc. to jesd22-a115a (machine model), 10 negative & 10 positive pulses. v machine model, 10 pulses input power p in 15 dbm wcdma-signal s s d21 f () h rrc ff carrier C () 2 f d h rrc f () 2 f1 = d
5 november 13, 2009 b9459 1880.0 mhz saw components saw tx filter data sheet please read cautions and warnings and important notes at the end of this document. transfer function for cw signals transfer function (wideband)
6 november 13, 2009 b9459 1880.0 mhz please read cautions and warnings and important notes at the end of this document. saw components saw tx filter data sheet transfer function for wcdma signals (powertransferfunction vs. carrier frequency) transfer function for wcdma signals (powertransferfunction vs. carrier frequency)
7 november 13, 2009 b9459 1880.0 mhz saw components saw tx filter data sheet please read cautions and warnings and important notes at the end of this document. smith charts unbalanced output (pin4) unbalanced input (pin1)
8 november 13, 2009 b9459 1880.0 mhz please read cautions and warnings and important notes at the end of this document. saw components saw tx filter data sheet references type b9459 ordering code B39192B9459P810 marking and package c61157-a8-a14 packaging f61074-v8237-z000 date codes l_1126 s-parameters b9459_nb.s2p b9459_wb.s2p see file header for port/pin assignment table. soldering profile s_6001 rohs compatible defined as compatible with the following documents: "directive 2002/95/ec of the european parliament and of the council of 27 january 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment. 2005/618/ec from april 18th, 2005, amending directive 2002/95/ec of the european parliament and of the council for the purposes of establishing the maxi- mum concentration values for certain hazardous substances in electrical and electronic equipment." moldability before using in overmolding environment, please contact your epcos sales office. for further information please contact your local epcos sales office or visit our webpage at w ww.epcos.com . published by epcos ag surface acoustic wave components division p.o. box 80 17 09, 81617 munich, germany ? epcos ag 2009. this brochure replaces the previous edition. for questions on technology, prices and delivery please contact the sales offices of epcos ag or t he international representatives. due to technical requirements components may contain dangerous substances. for information on t he type in question please also contact one of our sales offices.
9 november 13, 2009 important notes t he following applies to all products named in this publication: 1. some parts of this publication contain statements about the suitability of our products for certain areas of application . these statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. we nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a particular customer application. as a rule, epcos is either unfamiliar with individual customer applications or less familiar with them than the customers themselves. for these reasons, it is always ultimately incumbent on the customer to check and decide whether an epcos product with the properties described in the product speci?cation is suitable for use in a particular customer application. 2. we also point out that in individual cases, a malfunction of electronic components or failure before the end of their usual service life cannot be completely ruled out in the current state of the art, even if they are operated as speci?ed. in customer applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of an electronic component could endanger human life or health (e.g. in accident prevention or life-saving systems), it must therefore be ensured by means of suitable design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or failure of an electronic component. 3. the warnings, cautions and product-speci?c notes must be observed. 4. in order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as hazardous) . useful information on this will be found in our material data sheets on the internet (www.epcos.com/material). should you have any more detailed questions, please contact our sales of?ces. 5. we constantly strive to improve our products. consequently, the products described in this publication may change from time to time . the same is true of the corresponding product speci?cations. please check therefore to what extent product descriptions and speci?cations contained in this publication are still applicable before or when you place an order. we also reserve the right to discontinue production and delivery of products . conse- quently, we cannot guarantee that all products named in this publication will always be available. the aforementioned does not apply in the case of individual agreements deviating from the foregoing for customer-speci?c products. 6. unless otherwise agreed in individual contracts, all orders are subject to the current version of the general terms of delivery for products and services in the electrical industry published by the german electrical and electronics industry association (zvei) . 7. the trade names epcos, baoke, alu-x, ceradiode, csmp, cssp, ctvs, dssp, miniblue, minicell, mkk, mlsc, motorcap, pcc, phasecap, phasecube, phasemod, phicap, siferrit, sifi, sikorel, silvercap, simdad, simid, sineformer, siov, sip5d, sip5k, thermofuse, windcap are trademarks registered or pending in europe and in other countries. further information will be found on the internet at www.epcos.com/trademarks. t he following applies to all products named in this publication: 1. some parts of this publication contain statements about the suitability of our products fo r certain areas of application . these statements are based on our knowledge of typica l requirements that are often placed on our products in the areas of application concerned. w e nevertheless expressly point out that such statements cannot be regarded as bindin g statements about the suitability of our products for a particular customer application . as a rule, epcos is either unfamiliar with individual customer applications or less familia r with them than the customers themselves. for these reasons, it is always ultimatel y incumbent on the customer to check and decide whether an epcos product with th e properties described in the product speci?cation is suitable for use in a particular custome r application. 2. we also point out that in individual cases, a malfunction of electronic components o r failure before the end of their usual service life cannot be completely ruled out in th e current state of the art, even if they are operated as speci?ed. in customer application s requiring a very high level of operational safety and especially in customer applications i n which the malfunction or failure of an electronic component could endanger human life o r health (e.g. in accident prevention or life-saving systems), it must therefore be ensured b y means of suitable design of the customer application or other action taken by the custome r (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustaine d by third parties in the event of malfunction or failure of an electronic component. 3. the warnings, cautions and product-speci?c notes must be observed. 4. in order to satisfy certain technical requirements, some of the products described in thi s publication may contain substances subject to restrictions in certain jurisdictions (e.g . because they are classed as hazardous) . useful information on this will be found in ou r material data sheets on the internet (www.epcos.com/material). should you have any mor e detailed questions, please contact our sales of?ces. 5. we constantly strive to improve our products. consequently, the products described in thi s publication may change from time to time . the same is true of the corresponding produc t speci?cations. please check therefore to what extent product descriptions and speci?cation s contained in this publication are still applicable before or when you place an order. we also reserve the right to discontinue production and delivery of products . conse - quently, we cannot guarantee that all products named in this publication will always b e available. the aforementioned does not apply in the case of individual agreements deviatin g from the foregoing for customer-speci?c products. 6. unless otherwise agreed in individual contracts, all orders are subject to the curren t version of the general terms of delivery for products and services in the electrica l industry published by the german electrical and electronics industry associatio n (zvei) . 7. the trade names epcos, baoke, alu-x, ceradiode, csmp, cssp, ctvs, dssp, miniblue , minicell, mkk, mlsc, motorcap, pcc, phasecap, phasecube, phasemod, phicap , siferrit, sifi, sikorel, silvercap, simdad, simid, sineformer, siov, sip5d, sip5k , thermofuse, windcap are trademarks registered or pending in europe and in othe r countries. further information will be found on the internet at www.epcos.com/trademarks.
|
