PIC-P18B PROTOTYPE BOARD FOR 18 PIN PIC MICROCONTROLLERS Features: PIC-P18B is prototype board for 18 pin PIC microcontrollers with following features: - RS232 Tx, Rx interface with MAX232 IC - ICD/ICSP 6 pin connector - Status LED connected to RB3 via removable jumper - 4MHz, or 20MHz quartz oscillator - extension slot on each microcontroller pin - DIL18 microcontroller socket - power supply plug in connector - +5V power supply voltage regulator - 0.1" (2.54 mm) grid - dimensions: 100x80 mm - four mounting holes from http://www.picallw.com or Goodwin's free software www.lpilsley.uklinux.net Nigel from ICD/ICSP connector layout: The ICD/ICSP connector is 6 pin with 0,1" step. The PIN.1 is marked with square pad on bottom and arrow on top. ICSP signals are: 1- MCLR, 2VDD, 3- VSS/GND, 4- PGD/RB7, 5- PGC/RB6, 6- PGM/RB3. RS232 interface: J2 removable jumper selects where RTS/DTR line to be connected. In position 12 the line is connected to RTS, in position 23 is connected to DTR. Status LED: Connected to RB3 via removable jumper J2. The jumper should be left open while programming. Oscillator circuit: Crystal resonator connected to OSC1 and OSC2. Programming: To program PIC-P18B you need serial port or parallel port PIC programmers with ICSP connector (PIC-PG1, PIC-PG3B) or PIC-ICD1B. The serial port ICSP programmer (PIC-PG1) works with IC PROG ICPROG software, written by Bonny Gijzen. The latest release of ICPROG may be download for free from http://www.icprog.com The parallel port ICSP programmer (PIC-PG3B) works with Bojan Dobaj's shareware software Supported devices: All 18 pin PIC microcontrollers. Power supply: The power supply should be in range +7.5 +18VDC. Ordering codes: PIC-P18B-4MHz PIC-P18B-20MHz PIC-P18B/PCB - assembled and tested - assembled and tested - only PCB Copyright(c) 2002, OLIMEX Ltd, All rights reserved. Development boards for PIC, AVR and MSP430 microcontrollers http://www.olimex.com/dev
|