| PART |
Description |
Maker |
| F-LBAND-TX F-LBAND-RX |
Typical L-BAND-Rx/Tx Application
|
THOR communications
|
| 3CU3.5 3CU1 3CU1.6 3CU16 3CU20 3CU25 3CU30 3CU13 3 |
V-EA-Series - UL508 Manual Motor Controller
|
Altech corporation
|
| 2B1.6UM 2B13UM 2B1UM 2B10UM 2B15UM 2B16UM 2B2.5UM |
V-EA-Series - UL508 Manual Motor Controller
|
Altech corporation
|
| BGA310 |
Silicon Bipolar MMIC-Amplifier (Cascadable 50 W-gain block 9 dB typical gain at 1.0 GHz 9 dBm typical P-1dB at 1.0 GHz 3 dB-bandwidth: DC to 2.4 GHz)
|
Siemens Semiconductor Group
|
| HN7G02FU |
Multi Chip Discrete Device Power Management Switch Application, Inverter Circuit Application, Driver Circuit Application and Interface Circuit Application.
|
TOSHIBA
|
| FMCE-0528 FMCE-0528-TR |
Attenuation to 60 dB at 500 kHz, typical Operating temperature -55掳 to 125掳C
Attenuation to 60 dB at 500 kHz, typical Operating temperature -55° to 125°C
|
Interpoint Corporation Company
|
| MCP6542 MCP6542-I/MS MCP6542-I/P MCP6542-I/SN MCP6 |
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current ...
Push-Pull Output Sub-Microamp Comparators
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the 16 lead PDIP, SOIC and 14 lead TSSOP pack
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package,
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package.
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC, MSOP and five le
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current ...
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
From old datasheet system
IC,VOLT COMPARATOR,DUAL,CMOS,TSSOP,8PIN,PLASTIC
|
Microchip Technology Inc.
|
| MCP603T-E/ST MCP603T-I/ST MCP6022-I/SN MCP6022-I/S |
MCP603 operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 and an offset ...
The MCP602 dual operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 ...
MCP601 operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230 and an offset ...
The MCP604 quad operational amplifier (op amp) has a gain bandwidth product of 2.8 MHz with low typical operating current of 230. ...
|
Microchip
|
| U20DL2C48A 20DL2C48A U20FL2C48A 20FL2C48A E000406 |
Switching Power Supply Application High Efficiency Diode(用于开关型电源的高效二极管)
DIODE(CWITCHINGTYPEPOWERSUPPLYAPPLICATION)
SWITCHING TYPE POWER SUPPLY APPLICATION CONVERTER & CHOPPER APPLICATION
DIODE (CWITCHING TYPE POWER SUPPLY APPLICATION)
From old datasheet system
|
Toshiba Corporation
ToshibaSemiconductor
TOSHIBA[Toshiba Semiconductor]
|
| U2FWJ44M |
SWITCHING MODE POWER SUPPLY APPLICATION PORTABLE EQUIPMENT BATTERY APPLICATION
|
Toshiba Semiconductor
|
