| PART |
Description |
Maker |
| DS3992Z-18P DS3992Z-18N DS3992Z-09N DS3992Z-09P |
Two-Channel, Push-Pull CCFL Controller 双通道，推挽式CCFL控制
|
Maxim Integrated Products, Inc.
|
| AAT4296 AAT4298 |
Five/Six Channel Push/Pull I/O Expander
|
Advanced Analogic Technologies
|
| ARF476FL |
RF POWER MOSFET N-CHANNEL PUSH - PULL PAIR
|
Microsemi Corporation
|
| GFZ |
Push-Pull Four Channel H Bridge Drivers(推挽式四通道H桥驱动器)
|
意法半导
|
| RBHV57908DG HV57908X HV57908 HV57908DG HV57908PG |
8 MHz, 64-Channel Serial To Parallel Converter With Push-Pull Outputs
|
Supertex Inc
SUTEX[Supertex, Inc]
|
| MX8771 MX8771R MX8771RTR |
16-Channel, 60V Driver Push-Pull Output, I2C Interface
|
IXYS Corporation
|
| HV583 HV583X |
128 Channel Serial to Parallel Converter with Push-Pull Outputs 128通道串行与并行转换器推式输出
|
Supertex, Inc.
http://
|
| HV9308 HV9308PJ HV9308X HV9408PJ HV9408X HV9408 |
32-Channel Serial To Parallel Converter With High Voltage Push-Pull Outputs
|
SUTEX[Supertex, Inc]
Supertex Inc
Supertex Inc
|
| MCP6542 MCP6542-I/MS MCP6542-I/P MCP6542-I/SN MCP6 |
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current ...
Push-Pull Output Sub-Microamp Comparators
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the 16 lead PDIP, SOIC and 14 lead TSSOP pack
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package,
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package.
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC, MSOP and five le
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current ...
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
From old datasheet system
IC,VOLT COMPARATOR,DUAL,CMOS,TSSOP,8PIN,PLASTIC
|
Microchip Technology Inc.
|
| HV509K6-G |
16-Channel Serial to Parallel Converter with High Voltage Backplane Driver and Push-Pull Outputs
|
Supertex, Inc
|
| ADM1815-10AKS-REEL ADM1815-10AKS-RL7 ADM1815-10ART |
Microprocessor Supervisory in SOT-23 with Active Low Push-Pull Output Choices
Microprocessor Supervisory in SOT-23 with Active High and Low Push-Pull Output, Positive Reset Output
Microprocessor Supervisory in SOT-23 with Low Active OpenDrain Output Choices
Microprocessor Supervisory in SOT-23 with Active Low Open Drain Output Choices
Microprocessor Supervisory in SOT-23 with Active High Push-Pull Output
Microprocessor Supervisory in SOT-23 with Open Drain Output Choices
1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3
|
ANALOG DEVICES INC
|
| CGY887B CGY887B_1 CGY887B-2015 |
860 MHz/ 27.8 dB gain push-pull amplifier
From old datasheet system
860 MHz, 27.8 dB gain push-pull amplifier
|
Quanzhou Jinmei Electronic ...
NXP Semiconductors
Philips Semiconductors
|
